View source for Linear 2D Designer Quick Start

=='''Add Bend'''==
'''Adding a bend''' can be done two different ways:

'''1.)''' While the part is being designed, '''each click''' of the mouse will '''place a new bend'''. (The start and end length of the part are an exception.)

[[File:2daddbend1.png|500px]]

'''2.)''' After the finish button has been clicked, the '''add bend button''' [[File:addbend.png]] will become available. Click it to add a new bend. Once clicked, the part will be in design mode again and a blue line will be attached to the end of the part. In the part display, click the new end location of the part. If necessary, continue to pick further points to add more bends. 




=='''Remove Bend'''==
While the part is being designed, the '''undo''' last [[File:undo.png]] button can be clicked to remove the last bend on the part.

[[File:2dundolast.png|600px]] 

=='''Adjust Lengths'''==

=='''Adjust Angles'''==

=='''Adjust Rotation'''==

=='''Dimension Types'''==

=='''Start Over'''==

=='''Finish'''==

=='''180° Bends'''==