Template Rotation Tutorial - Revision history

Fabcam1 at 15:47, 28 August 2013

2013-08-28T15:47:44Z

Fabcam1 at 19:14, 15 July 2013

2013-07-15T19:14:56Z

Fabcam1 at 16:09, 12 July 2013

2013-07-12T16:09:18Z

Fabcam1: Created page with "==Introduction== This tutorial will step through the process of adding a rotation to a template with the template rotation plug-in. The template rotati..."

2013-07-12T16:02:15Z

Created page with "==Introduction== This tutorial will step through the process of adding a rotation to a template with the template rotation plug-in. The template rotati..."

New page

==Introduction==
This tutorial will step through the process of adding a rotation to a template with the [[Template Rotation|template rotation]] plug-in.

The template rotation plug-in allows rotations to be added to parts created using the [[Template Designer|template designer]].

==Tutorial==

==='''Note'''===
Before starting the tutorial, a part must be created. This tutorial will be using the part that was created in the '''[[Template Designer Tutorial]]'''. '''Please complete the Template Designer tutorial before proceeding'''.

==='''Step 1'''===
Once the part is complete, '''locate the rotation field next to the entry fields''' on the left side of the screen, as shown below. Since this part has only 2 bends, there will only be one rotation field available.

[[File:temprot01.png]]

==='''Step 2'''===
Next, a rotation value will be applied to the part.

'''Enter "90" in the rotation field'''. This will add a rotation to the second bend on the part. See the image below.

[[File:temprot02.png|700px]]

← Older revision		Revision as of 15:47, 28 August 2013
Line 26:		Line 26:

	==='''Note'''===		==='''Note'''===
−	Before starting the tutorial, a part must be ~~created~~. This tutorial will be using the part that was created in the '''[[Template Designer Tutorial]]~~'''. '''Please complete the Template Designer tutorial before proceeding~~'''.	+	Before starting the tutorial, a part must be completed. This tutorial will be using the part that was created in the '''[[Template Designer Tutorial]]'''.

← Older revision		Revision as of 16:09, 12 July 2013
Line 30:		Line 30:

	[[File:temprot02.png\|700px]]		[[File:temprot02.png\|700px]]
		+
		+
		+
		+
		+
		+
		+	==='''Step 3'''===
		+	'''The tutorial is complete!'''
		+
		+	Rotations applied to the template design will be included in the '''results table at the top of the window'''.
		+
		+	[[File:temprot03.png\|700px]]

@@ Line 1: / Line 1: @@
 ==Introduction==
-This tutorial will step through the process of adding a rotation to a template with the [[Template Rotation|template rotation]] plug-in.
+[[File:temprot05.png|right|450px]]This tutorial will step through the process of adding a rotation to a template with the [[Template Rotation|template rotation]] plug-in.
 The template rotation plug-in allows rotations to be added to parts created using the [[Template Designer|template designer]].