Difference between revisions of "Grapple Designer Tutorial"

Revision as of 14:15, 1 July 2013

This tutorial will step through the process of designing a part (Shown to the right) in the grapple part designer interface.

While designing a part in the grapple designer, the die and material are chosen and the part is designed by clicking and dragging the grapple tool.

Note: This tutorial will use millimeters as the measurement units.

First, a new grapple part design needs to be started. On the start up page, click the grapple designer button.

Note: Depending on the version of software currently in use, fewer designer buttons may be included on the start up page.

Now a new grapple part designer window will open. This is where the part will be designed.

@@ Line 1: / Line 1: @@
 ==Introduction==
+[[File:grapptut4.png|right|500px]]This tutorial will step through the process of designing a part (Shown to the right) in the [[Grapple Designer|grapple part designer]] interface.
+While designing a part in the grapple designer, the die and material are chosen and the part is designed by clicking and dragging the grapple tool.
+'''''Note:''''' ''This tutorial will use millimeters as the measurement units.''
 ==Tutorial==
 ==='''Step 1'''===
+First, a '''new grapple part design''' needs to be started. On the start up page, click the '''grapple designer''' button. [[File:grapptut3.png]]
+'''''Note:''''' ''Depending on the version of software currently in use, fewer designer buttons may be included on the start up page.''
+[[File:grapptut2.png|400px]]
 ==='''Step 2'''===
+Now a '''new grapple part designer window will open'''. This is where the part will be designed.
+[[File:grapptut5.png|700px]]
 ==='''Step 3'''===