Template Designer Quick Start

Adjust Lengths

To adjust the lengths of a template part, enter values into the designer entry fields that mark the straight lengths of the part.

Adjust Angles

Only certain template parts allow for an angle adjustment. If an angle adjustment is available, the angle field will have a "Bend Angle" label next to it.

To change the angle, enter a new value into the angle field.

Adjust Rotation

The ability to add rotations to a template part is only available if the template rotation plug-in is included in the current version of the software.

To add rotations to bends, enter new values into the rotation fields below the arrow icon in the left panel.

Dimension Types

Each template will have between one and three different dimension type options: Inside, Center, or Outside. These can be chosen at the initial template selection or during the design process.

Dimension Types:

• or Outside Dimensions: The dimensions will be measured from the inside edges of the tube.

• or Center Dimensions:: The dimensions will be measured from the center line of the tube.

• or Inside Dimensions: The dimensions will be measured from the outside edges of the tube.

To choose a dimension type at the initial selection window, click on one of the dimension icons below the template tile. If necessary, this can be changed later.

To choose a dimension type during the design process, click one of the dimension options below the designer entry fields on the left panel.