Spring-back Charts

Description

The spring-back charts plug-in allows each die to be given spring-back/overbend and achieved angles to create a full spring-back chart. As more and more spring-back entries are added to a die, the full spring-back chart will become much more accurate.

On the left side of the window, there is a list of all the dies in the die library. In the middle of the window, there is a chart of the spring-back values that the currently selected die has been tested for. The add, delete, and edit entry buttons are located below this chart. On the far right of the window, there is a full spring-back chart. If there are no spring-back values for the currently selected die, this chart will not appear.

How To

Start Up

To access the spring-back charts, click on the settings menu on the main tool bar. Click on the spring-back library option, as shown below.

Add Entry

To add an entry to a die, first click on the die in the die list to the left. Then click on the add entry button. After that is clicked, another small window will open. In this window, the date, the measured bend angle, and the spring-back(overbend) angle ban be supplied. The measured bend angle is the actual angle that the part was bent to. The spring-back or overbend angle is the angle that the part needed to be bent to to achieved the measured angle. Once this information is entered, click the green check button to add it to the spring-back chart.

Delete Entry

To delete an entry, first select the die that the entry will be deleted from. Select the entry in the entry chart by clicking in any cell in the entry's row. When a cell is selected, it will be highlighted in blue. Click on the delete button to remove it from the chart.

Error creating thumbnail: Unable to save thumbnail to destination

Edit Entry

To edit/change an entry's angle values, first select the die in the die list to the left. Select the entry in the entry chart by clicking in any cell in the entry's row. Once a cell is selected, it will be highlighted in blue. Click on the edit button. Once the edit button is clicked, the original entry menu will be opened. Edit any of the necessary information by changing the values in the given fields. Click the green check button to save the changes. To cancel editing and not save any changes, click the grey X button.

Full Chart

Once at least one entry is added to the die, the full spring back chart will be generated. This chart will have spring-back or overbend angles for angles from 1° to 180° for the current die. As more entries are added, the chart's accuracy will increase. The first column represents the actual bend angle and the second column represents the spring-back/overbend angle or angle that the bend must be bent to to achieve the actual angle.

The angle values that were added to the entry chart will be highlighted in green, as shown below.

Caution: If the software detects any problems with the values that are generated, the spring-back/overbend column will be highlighted in yellow. If this happens, please double check the entry values to ensure they are correct before proceeding.