Linear Advanced Designer Quick Start

From Tube Software Wiki
Revision as of 09:46, 10 July 2013 by Fabcam1 (talk | contribs)
Jump to: navigation, search

Add/Remove Bends

The number of bends in a part is chosen from the bend number drop down menu in the left panel. To increase or decrease the number of bends, click the drop down menu and choose a number from the list.

Numbends2.png



Adjust Lengths

To change the length of a straight, enter a new value into the corresponding length field in the designer entry fields on the left panel.

Linadvlengths.png



Adjust Angles

To change the angle of a bend, enter a new value into the corresponding angle field in the designer entry fields on the left panel.

Linadvangles.png



Adjust Rotation

To adjust the rotation, enter a new value into the rotation field in the designer entry fields on the left panel. Note: Leaving a rotation field blank will have the same effect as a zero.

Linadvrotate.png



Dimension Types

Linadvdimtypes2.png
In the linear dynamic designer, there is the ability to change the location of the dimensions on either side of each bend.


The icons on either side of the entry fields represent the dimension locations. The column of icons on the left side are the locations for the start of each dimension and the icons on the right side are the locations for the ends of each dimension.


The first dimension icon after the first row in the designer entry fields determines the dimension type for the end of the dimension directly before the first bend. The following dimension icons on either end of the bend rows determine the dimension types for each end of the bends. The last dimension icon determines the dimension type for the end of the dimension directly after the last bend.



Linadvdimtypes.png


To change the dimension type, click on the dimension icon. The dimension type menu will open and a type can be selected by clicking on one of the dimension type tiles.

Lapart03.png


  • Dimtype01.png Tangent: The dimension will go to the tangent of the bend.
  • Dimtype02.png Outside Apex: The dimension goes along the outside of the tube to the apex of the bend.
  • Dimtype03.png Center-line Apex: The dimension goes along the center-line of the tube to the apex of the bend.
  • Dimtype04.png Inside Apex: The dimension goes along the inside of the tube to the apex of the bend.
  • Dimtype05.png Outside Perpendicular: The dimension goes along the tube to the perpendicular point on the outside of the bend. (Note: Should be used on bends of 90° or greater for it to have an effect.)
  • Dimtype06.png Center-line Perpendicular: The dimension goes along the tube to the perpendicular point in the center of the bend. (Note: Should be used on bends of 90° or greater for it to have an effect.)
  • Dimtype07.png Inside Perpendicular: The dimension goes along the tube to the perpendicular point on the inside of the bend. (Note: Should be used on bends of 90° or greater for it to have an effect.)



180° Bends

In the linear advanced designer, 180° bends are handled the same as any other bend.

To add a 180° bend, enter "180" into the angle field on the left panel.

Linadv180.png

Retrieved from "http://tubesoftwareengineering.com/wiki/index.php?title=Linear_Advanced_Designer_Quick_Start&oldid=1660"