Grapple Designer Tutorial

Introduction

This tutorial will step through the process of designing a part (Shown to the right) in the grapple part designer interface.

While designing a part in the grapple designer, the die and material are chosen and the part is designed by clicking and dragging the grapple tool.

Note: This tutorial will use millimeters as the measurement units.

Tutorial

Step 1

First, a new grapple part design needs to be started. On the start up page, click the grapple designer button.

Note: Depending on the version of software currently in use, fewer designer buttons may be included on the start up page.

Step 2

Now a new grapple part designer window will open. This is where the part will be designed.