Grapple Designer Quick Start

Add Bend

Adding a bend can be done two different ways:

1.) By double clicking on the center of the grapple tool (not a handle).

2.) By clicking the add bend button.

After a new bend has been added, the main axis will move to the new bend's location, as shown below.

Remove Bend

To remove the last bend added to a part, click the delete bend button.

Select a Bend

Selecting a bend can done by clicking directly on the bend in the part display. When hovering the mouse over a bend, it will show a grey grapple shape around the bend, as shown to the right. Click on it to select. Bends can also be selected by clicking on the bend in the bend list.

Adjust Lengths

Before adjusting the length, select the bend on the end of the length. Adjusting a length on a part can be done using any of the following three methods:

1.) By clicking and dragging a grapple tool handle in the direction of the straight tube.

2.) By clicking a grapple tool handle that points in the direction of the straight tube and keying in the length value.

3.) By entering a value into the length field next to the ruler icon below the entry fields in the left panel.

Adjust Angle

Adjusting the angle of a bend can be done using any of the following three methods:

1.) By clicking and dragging a grapple tool handle in the direction of the angle.

2.) By clicking on a grapple tool handle that goes in the direction of angle and keying in a distance value. The value that is given will not be the angle value - it will be how far the tube will move in a certain distance to create the angle.

3.) By entering new values into any of the angle entry fields in the left panel.

Once more than one angle is applied to a bend (Example: Pulled the light blue handle and then pulled the red handle), the angle as well as the axis that the angle is along will be shown below the value fields in the left panel next to an axis icon. The colors of the small arrows on this icon correspond to the axes that the angle is along. The angle value can be also edited by entering a value directly into the given field.

If more than two angles are added to the bend, two more angle values will be generated. These will also have axis icons that will show which axes the angles are along. These can also be edited by directly entering values into the fields.

Individual bends' angles can be locked by clicking on and toggling the lock icon on or off. When a bend is locked, the angles of the bend will be locked in place if any attempts to change them are made. While locked, dragging the grapple tool around will only adjust the length of the straight after the bend.

Note: Be very careful when adjusting locked bends! Depending on the combination of angles on the bend, adjusting a locked bend can sometimes force the straight length to extend far past the intended length.

Adjust Rotation

To adjust the rotation of a bend, any of the following three methods can be used:

1.) By clicking and dragging a grapple handle in the direction of the rotation.

2.) By clicking the grapple handle that points in the direction of rotation and keying in the moving distance.

3.) By entering new values into any of the entry fields in the left panel.

Dimension Types

When creating parts in the grapple designer, all dimensions are measured from the apex of each bend. In this specific designer, there is no option to change this.

Start Over

To completely start over and delete all bend information, click the start over button. Take caution when using this function. Once a part has been started over, it's information cannot be retrieved again.

180° Bends

To create a bend of 180° in the grapple designer, two 90° bends must be added with a small amount of straight tube in between them.