Difference between revisions of "Linear 2D Designer Quick Start"
(→Add Bend) |
(→Remove Bend) |
||
| Line 9: | Line 9: | ||
=='''Remove Bend'''== | =='''Remove Bend'''== | ||
| − | While the part is being designed, the '''undo''' last [[File:undo.png]] button can be clicked to remove the last bend on the part. | + | While the part is being designed, the '''undo''' last [[File:undo.png]] button can be clicked to '''remove the last bend''' on the part. |
| − | |||
| − | |||
| − | |||
| − | |||
| + | [[File:2dundolast.png|600px]] | ||
=='''Adjust Lengths'''== | =='''Adjust Lengths'''== | ||
Revision as of 13:50, 28 May 2013
Contents
Add Bend
Adding a bend can be done two different ways:
1.) While the part is being designed, each click of the mouse will place a new bend. (The start and end length of the part are an exception.)
2.) After the finish button has been clicked and the part is not currently being designed, the add bend button 
will become available. Click it to add a new bend. Once clicked, the part will be in design mode again and a blue line will be attached to the end of the part. In the part display, click the new end location of the part. If necessary, continue to pick further points to add more bends.
Remove Bend
While the part is being designed, the undo last 
button can be clicked to remove the last bend on the part.
Adjust Lengths
To adjust the length of a straight section, enter a new value into the corresponding length field in the left panel.
