Linear 2D Designer Quick Start

Add Bend

Adding a bend can be done two different ways:

1.) While the part is being designed, each click of the mouse will place a new bend. (The start and end length of the part are an exception.)

2.) After the finish button has been clicked, the add bend button will become available. Click it to add a new bend. Once clicked, the part will be in design mode again and a blue line will be attached to the end of the part. In the part display, click the new end location of the part. If necessary, continue to pick further points to add more bends.

Remove Bend

While the part is being designed, the undo last button can be clicked to remove the last bend on the part.

Adjust Lengths

To adjust the length of a straight section, enter a new value into the corresponding length field in the left panel.