Simulation Tutorial

Introduction

This tutorial will step through the features and functions of the simulation plug-in.

The simulation plug-in is used to watch a basic animation of the part being bent, to adjust the bending order, and to save or print screen shots of any part of the bending sequence.

Tutorial

Note

Before starting the tutorial, a part must be created. This tutorial will be using the part that was created in the Linear 2D Designer Tutorial. Please complete the Linear 2D Designer tutorial before proceeding.

Step 1

Once the part is complete, go up to the top of the window and click the tools menu. Select the simulation option from the drop down menu to access the simulation plug-in.

Step 2

This will open the simulation plug-in window. To the left, there will be a chart containing the current bend order. Below the bend order chart, there will be bend order buttons that are used to adjust the bending order. Below those buttons, there will be three animation speed control settings. To the right of the window, there will be a frame containing the part and the die. This is where the simulation of part being bent will be displayed. Below the simulation frame, there will be buttons used to control the animation, change the bender type, and print or save the current position of the animation.

Step 3

First, make sure the bending order is set to the normal setting (bends go from 1 to 5, all are bend From Start ). If the order is not normal, click the normal bend order button.

Step 4

Click the play button to watch the bending simulation with the normal bend order. The simulation will restart again once the part is fully bent. Click the restart button after the simulation is complete to stop the animation and set it back to the beginning.

Step

Now, the bending order will be adjusted. A flip will be added between the second and third bends. Click the normal flip button.

A small menu box will appear where the location of the flip will be chosen. Click the drop down menu, select 2 & 3, and click the green check button.

See the bend order chart. The part will be bent in normal order up through the second bend. When the flip occurs, the bend order will be reversed completely.

Step

Next, the speed setting of the simulation will be set. There are three options: slow, normal, and fast. Click the slow button as shown below.