LRA Designer

Description

The LRA Designer allows parts to be created in full 3D. Parts are created by supplying length, rotations, and angle values for each bend. The straight length dimensions can be measured by the length of the straight sections of tube or by the distance from the apex of the bends. The option to give each bend a custom center-line radius value is also available.

How To

Start Up

To access this designer, click the LRA designer button . This will open a new, blank part design.

Part Design

Once a new LRA part design window has been opened, a new part can be created.

First, a die and material should be chosen. This can be done by clicking on the drop down menus next to the die and material icons in the top left corner of the screen.

If any cut-off is necessary, enter the amount needed into the start and end cut-off fields. The first/top field represents the cut-off at the start of the part and the second/bottom field represents the cut-off at the end of the part.

Choose the number of bends by clicking the drop down menu next to the list icon, as shown to the right. A single part can have up to 50 bends. The number of bends can be adjusted at any time in the design process.

Controls and Options

To change the way straight lengths of tube are measured, click on the distance to apex or length of straight buttons. See the image below for a basic explanation of these two options.

Notes can be attached to the part design project using the note button .

The auto-zoom option can be turned on or off using the auto-zoom button . When activated, auto-zoom will zoom in or out to accommodate the size of the part. For example, if a length is originally 200 and is changed to 2000, it may extend past the part display's extend. Auto-zoom will zoom out to make sure the whole part is visible.